Greenwatts

Assembly Details

Parts and tools required to build the Canuckle solar tracker (not including control circuit or mountings) include; ABS 4" cap, 3" cap, 2" cap, 1.5" T-fitting with drain plug, 1.5" drain plug, O-ring from drian plug, 1.5" elbow, 1.5" pipe. ABS cement, .625" 1.5" and 2" hole saws, utility knife, screw driver, drill and drill bits, fine flat file.

The circuit board can simply be placed inside the base housing. The cover for the motor gear head is not shown in this diagram. 1.5" ABS pipe can be used as arms extending out from each side of the top T-fitting and cut to suit the PV panel dimensions.